Some Effective Guidelines in Fixing a Screen in a Sunroom

Sunroom screens get damaged fairly quickly especially if you're frequently transferring them. To repair a tear or perhaps cut in the screen, you need to flatten the screen, estimate a patch of material, buy some wire strands, turn the strands into hooks, and acquire a brand new material.

In some cases, it becomes pretty irritating if you have just developed your sunroom and then one day you'll realize that the screen within your sunroom already requires fixing. While this might be discouraging, you could cut costs and fix your display on your own in a really economical manner. Here is exactly how to do it right:

Flatten the screen

Just before contacting a sunroom contractor, you might perhaps try fixing your screen yourself. Clearly, this depends on the degree of destruction done on your screen simply because some damages may be irreparable and might require specialist support. For starters, try smoothing out the surface of the screen to trim all the torn edges. This is very important because, in order to measure precisely how much materials you need, you need to make sure that the screen is initially flat and smooth as possible. You need to try executing this on a flat working surface for better precision.

Measure an area of material

After that, take a patch of cabled mesh and set this over the tear or hole. Draw or mark down the measurements around the material necessary to repair the opening. Even if this is only a temporary patch, you must make sure that you have enough material to last until you can obtain the expertise of a reliable sunroom contractor. Once you patch up your screen, it is better if you try to keep the homogeneity of the screen. In case you could no longer locate a material that is the same colour as the screen, search for one which is as similar as you can, so that the patch does not stand out very much.

Acquire some wire strands

You will then must have something to hold the wire in place. A great way to achieve this without utilizing separate cables would be to cut off a few wire strands from around the tear or opening on screen. The wires would then be protruding out. Ensure that these aren't too sharp or perhaps you can end up cutting yourself. Either utilize a piece of sand paper to smoothen out the corners or cut off all sharpened ends.

Transform the strands into hooks

Using a pair of pliers, bend the expanded wires into angles to build make shift hooks. You can then position your own patch of materials over these and bend the cables over and under the mesh of the patch to form, as much as possible, a smooth fix. This is better than using separate wires since it results in a less obvious mend. However, if the mesh of your screen is too small to enable this, you could think about using wire hooks to carry the patch in place.

Purchase a new material

A final resort to repairing your screen will be to buy a full length of new material. Although this might be costly, it is a more long-lasting solution when compared to repairing tears by patches. You may opt for components that are made from a much better quality to prevent the screen from ripping once again later on.

Get a material that is of an identical color and texture to that of the screen to have a more homogenous look. Alternatively, you can use any excess material from when you first installed the screen for this patching purpose.


------

Written by Patricia Strasser. In case you're looking for a sunroom contractor, check out http://www.alcoaconstruction.com/additions/sunrooms/